Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
tab – parameter overview
1
2
3
4
5
6
7
8
9
10
11
Secondary transformer current
Current on the secondary side of the transformer.
Effect on the Current sek indication on the tab 1
Reactor current (negative)
Current in the storage choke for the booster.
Effect on the “Current L” indication on the tab 1
DC link voltage
Intermediate circuit voltage.
Effect on the “DC link voltage” indication on the tab 1
System current
Specified current IREF on the analogue interface X105.
Clamp voltage
Voltage at the charging capacitor for the booster.
Effect on the “Voltage Clamp” indication on the tab 1
Output current Q4 (negative)
Actual value for the output current.
Effect on the “Output current” indication on the tab 1
System current IFB
The actual value of the output current is determined via a current sensor on
interface X108.
WR DC current IFB
DC term on the AC side.
The DC term should always be 0 A.
Phase voltages
Phase voltage for each phase L1, L2, L3
See Umax on the tab 1
Phase currents
Phase current for each phase L1, L2, L3
Effect on the Imax indication on the tab 1
Store settings
Settings made on the tab are permanently saved. The actual
parameter set is saved from the RAM to the flash PROM in the TC.GSS power
supply.
Table 120 tab
1 For tab overview see chapter 7.4.8.2, page 178.
2011-10-18 234 / 298 V00.05b
7