Manual

Manual – TopCon TC.GSS
Options and system options
Interface options
5.4.5. USB interface option – Universal Serial Bus
Fig. 50 USB interface -1- in combination with RS-232 REAR interface -2-.
Installation of the interfaces
The interface is built into the rear side of the device. It can be retrofitted
to a device or be already installed on delivery.
Combination with other interfaces
The interface is always supplied in combination with the RS-232
REAR interface.
The RS-232 REAR interface takes over the tasks of the RS-232
interface on the front side of the device.
Technical characteristics
Type: socket for USB plugs of type B (see Fig. 50 oben)
Interface standard: USB 1.1
Function
This is a serial interface and corresponds to the functionality of the
RS-232 interface. The USB interface is used for the transparent transmission
of data and can as a consequence be utilised both using the
DLL and directly at the low protocol level.
The USB driver for the PC included must be installed for it to be possible
to detect and operate the TC.GSS power supply from the operating
system.
2011-10-18 92 / 298 V00.05b
1
5
2