Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
“Voltage sensing” group
Condition for the usage of the sense function:
TC.GSS power supplies not connected in series
Connection of the interface to the overall circuit
Activation of the sense function has an effect on the display of the following
tabs:
tab
tab
For further information on the hardware, sense activation and its effects
see chapter 4.3.1, page 41.
1 1 2
Fig. 127 “Voltage sensing” group – parameters.
“Voltage sensing” group – parameters
1
2
3
4
5
Use sense input, check box
3 4 5
Selected: Function is switched on. All entries and check boxes for
“Voltage sensing” can be edited.
The following changes occur on the tabs:
tab labelled with sense
tab - sense parameters available
Cleared: Function is switched off
Max. voltage drop, text box
Maximum voltage compensation. The output voltage Uout is as a maximum =
USet + Max.Voltage drop,
where the reference value USet is defined via TopControl, analogue interface,
HMI/RCU or internally via the function generator.
Observe voltage drop, check box
Selected: Monitoring of the voltage difference Uout - Usense
“Error level” /”Error delay” text boxes are activated.
Cleared: Function is switched off
“Error level” /”Error delay” text boxes are deactivated.
Error level, text box
If the threshold set for the voltage difference Uout - Usense. is exceeded, the
device switches to the error status.
Error delay, text box
An “Error level” must be present for the time set before the device switches to
the error status.
Table 114 Parameters in the “Voltage sensing” group.
2011-10-18 223 / 298 V00.05b
7