Manual

Manual – TopCon TC.GSS
TopControl application
Tab –
“Status” and “Cursor” groups
1
2
1
2
Fig. 125 “Status” and “Cursor” groups – read-only indication.
“Status”/”Cursor” groups – read-only indication
1
2
3
Wait for trigger, read-only indication
As soon as the recording process has been opened via “Start Analyse” and if
immediate start was not selected (immediately mode),
the scope waits for a trigger event.
Indicator: Orange read-only indication.
Record (X %), read-only indication
Grey indication Recording not activated.
Green indication Recording activated, % indication of the recording time up to
now, see “Record time”, Table 111 Seite 217.
Cursor, group
Indicates the actual position of the cursor cross-wires.
See navigation in the scope display Fig. 116, Seite 202.
Table 112 Parameters in the “Time resolution” and “#sample points” groups.
2011-10-18 218 / 298 V00.05b
7
3