FS6200 Server System Implementation Guide - Public Support ...
FS6200 Server System Implementation Guide - Public Support ...
FS6200 Server System Implementation Guide - Public Support ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
The response to the NW NP command<br />
for a Network Services device indicates that<br />
the device is NASCENT.<br />
Some Ethernet Cable connectors are too wide<br />
to allow use of all four ports in Quad port NIC<br />
You cannot establish connections to network<br />
drives in the MCP Environment over a MCP<br />
network adapters path.<br />
During CNS initialization file processing on the<br />
MCP server, the following error message<br />
displays in response to an ADD<br />
CONNECTIONGROUP command for a<br />
Network Services MCP Network adapter:<br />
Invalid Attribute Value<br />
Troubleshooting and Recovery<br />
Check for a popup window on the I/O engine<br />
server for the Service Control Manager<br />
indicating that ″At least one service or driver<br />
failed during system startup. Use Event Viewer<br />
to examine the event log for details″. In this<br />
case, the event log would be the system event<br />
log.<br />
Look for log entries for the Service Control<br />
Manager of the appropriate date and time and<br />
examine them. If the description indicates that<br />
any of the Network Services or drivers failed to<br />
start or load then a reboot of the operating<br />
environment server is necessary to restart<br />
Network Services.<br />
Also, check for a popup window indicating that<br />
an application error has occurred and an<br />
application error log is being generated. If this<br />
window indicates that any of the Network<br />
Services is at fault then a reboot of the<br />
operating environment server is necessary to<br />
restart Network Services.<br />
In some rare cases, a Network Services<br />
uninstall and reinstall might be necessary to<br />
resolve the problem of one of the services or<br />
drivers not starting properly.<br />
Cables using molded connectors or boots for<br />
the connectors that are wider than the RJ45<br />
(8P8C) connector itself should not be used on<br />
the <strong>FS6200</strong> <strong>Server</strong>. Earlier ClearPath systems<br />
might have included or recommended cables<br />
with inappropriate connectors. These cables<br />
cannot be carried forward to the <strong>FS6200</strong><br />
<strong>Server</strong>.<br />
Verify that the NET object of the MCP View in<br />
the MCP Console is listed and running.<br />
Try using a PING command to the IP address of<br />
the MCP network adapter from a device on the<br />
same subnet.<br />
Verify that the value specified as the local<br />
address (in the initialization file ADD<br />
CONNECTIONGROUP command) matches<br />
the MAC address of the adapter NIC in the I/O<br />
engine.<br />
8222 3694–000 9–15
Change language