FS6200 Server System Implementation Guide - Public Support ...

Building Network Initialization Files
%
% The next command sets read-write access from a particular IP address
% Update the community value and the IP address; copy the command
% to give read-write access to multiple IP addresses/community strings.
%NW SNMP COMMUNITY ADD %
% ″community″ xxx.xxx.xxx.xxx ReadWrite;%
%
% The next command identifies a destination for traps from this system.
% Update the IP address to a valid IP address destination; copy the
% command to add more destinations.
%NW SNMP TRAPCOMMUNITY ADD %
% ″public″ xxx.xxx.xxx.xxx;%
%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
% Server Sentinel
% The next command adds SP0.
%NW SNMP COMMUNITY ADD %
% ″community″ xxx.xxx.xxx.xxx ReadWrite;%
%
% The next command adds SP1.
%NW SNMP COMMUNITY ADD %
% ″community″ xxx.xxx.xxx.xxx ReadWrite;%
%
% Add the external Management Server if it exists.
%NW SNMP COMMUNITY ADD %
% ″community″ xxx.xxx.xxx.xxx ReadWrite;%
%
% Define a SNMP TRAPCOMMUNITY for each Service processor and the
% external management server if it exists. As sites may/may not use the
% default IP addresses for SP0 and SP1, the IP address must be updated;
% the command must be uncommented to use. The community value does not
% need to be updated unless the ″public″ community value has not been
% defined on the system.
%
% Add SP0 Trapcommunity
%NW SNMP TRAPCOMMUNITY ADD %
% ″public″ xxx.xxx.xxx.xxx;%
%
% Add SP1 Trapcommunity
%NW SNMP TRAPCOMMUNITY ADD %
% ″public″ xxx.xxx.xxx.xxx;%
%
% Add the external Management Server trapcommunity if it exists.
%NW SNMP TRAPCOMMUNITY ADD %
% ″public″ xxx.xxx.xxx.xxx;%
%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
% The next command sets the SysContact, SysName, and SysLocation
% objects. Change the values in parentheses to meaningful values.
% (Do not remove the parentheses; they are needed for processing the
% command.)
NW SNMP SET
8222 3694–000 A–5