Manual - 8500A Series Peak Power Meter - Giga-tronics

Testing and Calibration
Giga-tronics Series 8500A
Calibration Data Recording Sheet
Make copies of this Data Sheet and use the copies for recordings. While proceeding through the
Calibration procedures, if any specification cannot be met by performing the given adjustments, go
immediately to Troubleshooting in Chapter 6 and follow the procedures to identify the problem.
Date:
Operator:
Temperature:
Model and Serial No:
Test Number (if required):
Humidity:
Manual Section Section Step Specification Reading
Regulator Board 5.3.3 A.3 +4.900 V to +5.100 V
5.3.3 A.4 Within 5 mV of A.3 reading
5.3.3 B.1 -5.000 V to -5.400 V
5.3.3 B.2 Within 5.2 mV of B.1 reading
5.3.3 C.3 -14.985 V to -15.015 V
5.3.3 C.4 Within 15 mV of C.3 reading
5.3.3 D.1 +14.995 V to +15.045 V
5.3.3 D.2 Within 15 mV of D.1 reading
A6
A7 (8502A Only)
Analog Board 5.3.6 A.3 +9.997 V to +10.003 V
5.3.6 B.5 -2 mV to +2 mV
5.3.6 C.3 -1 mV to +1 mV
5.3.6 D.4 -10 mV to +10 mV
5.3.6 D.6 +2.975 V to +3.025 V
5.3.6 D.8 -4.965 V to -5.035 V
5.3.6 E.2 Approx. 5000 mV
(±0.2 V/°C dev. from 30 °C)
GPIB/Cal Ctrl
Board
5.3.7 A.3 950 to 1050 MHz
CPU Board 5.3.8 A.3 30.517478 to 30.517678 µs
Digital Delay
Board
5.3.9 A.3 39.062400 to 39.062600 MHz
Ext. Interface 5.3.10 C.5 4.98 to 5.02 GHz
5.3.10 D.3 +5 Vdc
5.3.10 D.5 Approx. 0 Vdc
Manual No. 20790, Rev C, November 1998 5-23
Superceded by Revision D, March 2009