Manual - 8500A Series Peak Power Meter - Giga-tronics

Operation
knows to alter its frequency correction accordingly. The PPM then uses the proper frequency correction
accordingly. The PPM then uses the proper frequency correction for the detector(s) at each discrete
frequency point without necessitating any operator input or any calculations (see Section 2.8.2 more
information on the interfacing of external frequency signals.)
To make swept frequency measurements under pulsed conditions, equipment should be set up similar to
Figure 2-17. The measurement routine is initiated by pressing [MENU] (10) [F1].
During the time that the fast analog output mode is active, the display window will indicate:
FAST ANALOG OUTPUT
MEASUREMENT MODE
Press [MENU] to exit
Manual No. 20790, Rev C, November 1998 2-43
Superceded by Revision D, March 2009