Manual - 8500A Series Peak Power Meter - Giga-tronics

Series 8500A Peak Power Meters
Change Cursor Delay Move
cursor to CSR DLY line on
display, enter change using
Change Internal Trigger Level
Move cursor to TRG LEV line
on display, enter change using
Change Reference Power
(100% Point) Move cursor to
REF PWR line on display,
enter change using
[nn.nn] [UNITS] or spin knob
[nn.nn] [UNITS] (or spin knob), or use
[MENU] (1) [F1] [nn.nn] [UNITS]
[nn.nn] [UNITS]
A.5.3
A.5.4
Pulse Sub-Mode Commands
Function
Change Pulse Width Start and
End Percentages Move cursor to
PULSE WID line
Change Rise Time Start and
End percentages Move cursor
to RISE TIME line on display
Change Fall Time Start and
End Percentages Move cursor
to FALL TIME line on display
Marker Sub-Mode Commands
Function
Change Marker 1 Percentage
Move cursor to MRKR 2-1 line
on display
Change Marker 2 Percentage
Move cursor to MRKR 3-2 line
on display
Change Marker 3 Percentage
Move cursor to MRKR 4-3 line
on display
Change Marker 4 Percentage
Move cursor to 4th line on
display
Command Sequence
[nn.n] [UNITS] [nn.n] [UNITS]
[nn.n] [UNITS] [nn.n] [UNITS]
[nn.n] [UNITS] [nn.n] [UNITS]
Command Sequence
[snn.n] [UNITS]
[snn.n] [UNITS]
[snn.n] [UNITS]
[snn.n] [UNITS]
NOTE: Entering nn.n (positive) places the marker on the rising edge. Entering -nn.n (negative) places the marker on the falling edge.
A-4 Manual No. 20790, Rev C, November 1998
Superceded by Revision D, March 2009