Manual - 8500A Series Peak Power Meter - Giga-tronics

Menu and Memory Keys
MENU (11)
Minus = PREV MENU
Be Sure No RF is Applied to Detector
Press CLEAR to Skip All Tests
F1 for Service Fncts
F2 for Self Test
B.2.2
1018B Emulation Mode Functions
MENU (8)
1018B Emulate Mode, Bus Trigger Reset, SRQ Enabled
Press CLEAR to return to data display
SUB-MENU (8)
F1 to Disable SRQ (Service Request)
F2 for Automatic Trigger Reset
F3 to Get Data Fast; No EL Data Display
1018B Emulate Mode, Auto Trigger Reset, SRQ Disabled
Press CLEAR to return to data display
F1 to Enable Service Request
F2 for Bus Command Trigger Reset
F3 to Get Data Fast; No EL Data Display
NOTE: Pressing [MENU] (8) [F1] and then [MENU] (8) again will enable SRQ;
other SUB-MENU (8) items remain the same. Pressing [MENU] (8) [F2] and then
[MENU] (8) again will change Automatic Trigger to Bus Command in SUB-MENU
(8). All other SUB-MENU (8) commands remain the same.
MENU (9)
Menu = NEXT MENU; Minus = PREV MENU
Current Range Value is X
F1 for Range 1 (XXX.X µW)
F2 for Range 2 (XX.XX mW)
F3 for Range 3 (X.XXX mW)
MENU (10)
Press CLEAR to return to data display
Press MENU for next lower level menu
F2 to end 1018B Emulation
MENU (11)
MENU (12)
MENU (13)
1018B Emulate mode only. Same as MENU (8) for the normal 8500 mode.
1018B Emulate mode only. Same as MENU (9) for the normal 8500 mode.
1018B Emulate mode only. Same as MENU (10) for the normal 8500 mode.
Manual No. 20790, Rev C, November 1998 B-3
Superceded by Revision D, March 2009