Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Configuring and Using the 3D Simulation Tool EVOSim
A.14.3 Using EVOSim Splitter
EVOSim Splitter is only needed if you plan to use EVOSim in monitoring mode
and should only be run on the PC where Freedom EVOware is installed. Start
EVOSim Splitter before you start EVOSim. This displays the SplitterCtrl dialog box
which shows you the host name of the PC where EVOSim Splitter is running.
Specify the same host name in the Communication dialog box in EVOSim.
EVOSim Splitter does not have any configuration settings.
Click Accept in the SplitterCtrl dialog box to minimize EVOSim Splitter to the
system tray. It will then be shown as a small round icon at the bottom right of the
screen.
Right click the EVOSim Splitter icon to show a context menu with the following
items:
Exit
Quit EVOSim Splitter.
Info
Show the info screen for EVOSim Splitter.
About
Show the About box for EVOSim Splitter.
A.14.4 EVOSim Configuration Wizard
The EVOSim Configuration Wizard is used to specify the required configuration of
the simulated pipetting instrument. The configuration must be chosen to match
the requirements of the scripts and/or processes which you want to run in
Freedom EVOware. For example, if your script uses a PnP, you must also
configure a PnP in EVOSim.
You must specify the instrument configuration before you connect to Freedom
EVOware for the first time during the current EVOSim session. You cannot
change the instrument configuration after the connection to Freedom EVOware
has been established.
The starting screen of the EVOSim Configuration Wizard is as follows:
Fig. A-59 Starting screen of the Configuration Wizard
The options in the starting screen are as follows:
A - 106 Freedom EVOware Software Manual, 393172, en, V2.3