Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
Tab. A-86 Advanced worklist command Shaker_Stop, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 exec_parameters expression no execution parameters (specify an
empty string)
4 needs_allwd_lw expression specify 0 (does not need a specific labware
type)
5 allowed_labware expression not relevant (specify an empty string)
Example:
FACTS("Shaker","Shaker_Stop","","0","");
A.15.9.4 SetTemperature (Worklist: Shaker_SetTemperature)
The advanced worklist command which corresponds to the Te-Shake-Init device
command is “Shaker_SetTemperature”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.28.5 “Te-Shake shaker -
SetTemperature Command”, 16-92.
Tab. A-87 Advanced worklist command Shaker_SetTemperature, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 temperature expression required temperature in ºC * 10 (320 =
32ºC)
4 needs_allwd_lw expression specify 0 (does not need a specific labware
type)
5 allowed_labware expression not relevant (specify an empty string)
Example:
FACTS("Shaker","Shaker_SetTemperature","320","0","");
A.15.9.5 SetFrequency (Worklist: Shaker_SetFrequency)
The advanced worklist command which corresponds to the Te-Shake-
SetFrequency device command is “Shaker_SetFrequency”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.28.6 “Te-Shake shaker -
SetFrequency Command”, 16-93.
A - 172 Freedom EVOware Software Manual, 393172, en, V2.3