Software Manual Freedom EVOware Standard 2.3 Freedom ...

13 - Overview of Freedom EVOware Commands
Overview of Device Commands
Tab. 13-48 Commands for the Ultra Evolution Reader (cont.)
Open - The Open command opens the door of the reader. See 16.38.4 “Ultra Evolution
Reader - Open Command”, 16-124.
Close - The Close command closes the door of the reader. See 16.38.5 “Ultra Evolution
Reader - Close Command”, 16-124.
Measure - The Measure command performs a measurement procedure using external
software. See 16.38.6 “Ultra Evolution Reader - Measure Command”, 16-124.
Multilabel - The Multilabel command performs up to four consecutive measurement
steps on the same plate using external software. The plate does not have to leave the
reader in between measurements. See 16.38.7 “Ultra Evolution Reader - Multilabel
Command”, 16-125.
13.2.38 Commands for the Process Script, Overview
The following table lists the command for the Process Script device driver. This
command is only available in Freedom EVOware Plus.
Tab. 13-49 Commands for the Process Starter
Script - The Script command is used to create a script for the Process Starter script
commands. When you drag it to the Process Editor, it opens the Script Editor automatically.
See 16.39.1 “Process Script - Script Command”, 16-127.
13.2.39 Commands for the Transfer Station, Overview
The following table lists the command for the Transfer Station. The Transfer
Station is an unused location on the worktable of the pipetting instrument. If your
pipetting instrument is fitted with two RoMa arms, this location is used to transfer
labware from one RoMa to another. The Transfer command is only installed if you
have installed Freedom EVOware with two RoMas.
Tab. 13-50 Commands for the Transfer Station
Transfer - The Transfer Station is an unused location on the worktable of the pipetting
instrument. If your pipetting instrument is fitted with two RoMa arms, the Transfer
command uses the Transfer Station to pass labware from one RoMa to the other if
this becomes necessary. See 16.40.1 “Transfer Station - Transfer Command”, 16-
127.
13.2.40 Commands for the Te-Link, Overview
The following table lists the command for the Te-Link transfer rail.
This command is only available in Freedom EVOware Standard. In Freedom
EVOware Plus, when the labware is put down at either end of the transfer rail the
shuttle carrier starts to move automatically to the other end.
Freedom EVOware Software Manual, 393172, en, V2.3 13 - 35