Software Manual Freedom EVOware Standard 2.3 Freedom ...

8 - Configuration Tool
Device Driver Configuration
Magellan
Standard
Path: Specify the path which is configured in Magellan for workspace files. This
makes it easier to load the generated workspace files if you run Magellan on its
own later on.
Filename: If you are using a barcode scanner, you should specify the placeholder
, which will instruct Freedom EVOware and thus Magellan to generate the
filename from the labware barcode. It is not necessary to specify the file extension
(which is .wsp). Note: The labware must be scanned in advance of the Magellan
Measure command.
Examples:
c:\Documents and Settings\All Users\Documents\Tecan\Magellan\
or
c:\Documents and Settings\All Users\Documents\Tecan\Magellan\wsp\
Note: To check the paths which are configured in Magellan, start the Magellan
Wizard, click More and click Options. Then choose the Paths tab.
Magellan
Tracker
Path: Magellan Tracker stores the workspace files in the path which is configured
in Magellan and ignores the path that you specify here. Accordingly, it is
recommended to leave the Output File Default field blank for Magellan Tracker.
The filename and path of the workspace file will then be taken from the settings
which were made in the Magellan method.
Filename: If you are using a barcode scanner, you should specify the placeholder
, which will instruct Freedom EVOware and thus Magellan to generate the
filename from the labware barcode. It is not necessary to specify the file extension
(which is .wsp). Note: The labware must be scanned in advance of the Magellan
Measure command.
Example:
c:\Documents and Settings\All Users\Documents\Tecan\Magellan\wsp\
Note: In both Magellan Standard and Magellan Tracker, if you leave the Output
File Default field blank in Freedom EVOware, the filename and path of the
workspace file will be taken from the settings which were made in the Magellan
method.
Note: In Windows Explorer, the directory c:\Documents and Settings\All
Users\Documents is shown as “Shared Documents” and not “Documents”.
Miscellaneous panel
Temperature, Temperature Control
Check the Temperature Control checkbox if you want to carry out
measurements at a specified temperature. Then specify the required
temperature in the Temperature field.
Initialization Timeout
Specify the maximum duration of the reader initialization procedure. An error
message will be output if initialization is not completed within this time.
Power Down Timeout
Specify the delay after which the reader should go into standby (energy
saving) mode. Specify 0 if you do not want the reader to go into standby
mode. The reader can take several minutes to wake up from standby mode
before it is ready for use.
8 - 72 Freedom EVOware Software Manual, 393172, en, V2.3