Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Worklist Command
15.24.1 Decontamination Wash Settings
The decontamination wash operation soaks the tips in the specified liquid for a
specified time. It can be used e.g. to remove traces of sticky liquids from the tips
and is carried out before the main wash procedure:
Fig. 15-25 Worklist command - Decontamination Wash parameters
Decontamination Wash is specified in the worklist file with the WD record.
The parameters of the decontamination wash operation are as follows:
Tip Selection
The tip selection is shown for information only and cannot be changed. The
decontamination wash uses the same tip selection as the main wash
procedure.
Volume to aspirate
Specify the volume of wash liquid you want to aspirate (range: 1 to 1000 µl).
Use source
The wash liquid for the decontamination wash is aspirated from a trough
(liquid container). Choose the required trough from the pull down list. The list
shows all troughs which are currently positioned in the Worktable Editor.
Liquid Class
Choose the required liquid class from the pull down list. The list only shows
liquid classes which are suitable for the current configuration of the pipetting
instrument. For example, you will not see liquid classes for DiTis if the LiHa is
not currently configured with DiTis.
Delay after aspirate
Specify how long you want to soak the tips (range: 1 to 1800 s).
15.24.2 Worklist File Format
A worklist file is a text file containing pipetting instructions. The worklist
commands consist of individual lines (or records). Seven different record types
are available: Aspirate, Dispense, Wash Tips / Replace DITIs, Flush, Break, Set
DITI Type and Comment. Each record starts with a single character indicating the
type and is followed by one or more parameters. The parameters are separated
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 39