Software Manual Freedom EVOware Standard 2.3 Freedom ...

8 - Configuration Tool
Device Driver Configuration
Fig. 8-64 Conversion tab of the microplate reader driver
Measure panel
In some cases it may be necessary to convert the reader output data to a different
data format. Select Message to send a system message to any program
configured to listen to the message that the measurement command has been
completed and that the output data is ready for conversion. Please refer to the
documentation on the Freedom EVOware Programming Interface (API) for
information on developing external software which listens to Freedom EVOware
system messages.
Alternatively, you can specify an external program to be executed on completion
of the measurement command. Specify the path and file name of the external
program directly or click Browse and choose the required program. The name of
the file to be converted is passed to the external program as a command line
parameter.
8.5.35 Driver Tab of the Configure Device Driver Properties Dialog Box
The Driver tab is used to configure, add and delete device commands. You can
also specify the command execution times which should be used by the prescheduler
during simulation.
The Commands panel lists the device commands which are available for the
device you have selected (the example below is for the Ultra Reader):
8 - 116 Freedom EVOware Software Manual, 393172, en, V2.3