Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
A.15.11 Advanced Worklist Commands for the Te-Stack Stacker
The following describes the most important advanced worklist commands for the
Te-Stack Stacker.
A.15.11.1 InitStacker (Worklist: Te-Stacker_InitStacker)
The advanced worklist command which corresponds to the Te-Stack-InitStacker
device command is “Te-Stacker_InitStacker”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.34.1 “Te-Stack - InitStacker
Command”, 16-108.
Tab. A-94 Advanced worklist command Te-Stacker_InitStacker, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 exec_parameters expression no execution parameters (specify an
empty string)
4 needs_allwd_lw expression specify 0 (does not need a specific labware
type)
5 allowed_labware expression not relevant (specify an empty string)
Example:
FACTS("Te-Stacker","Te-Stacker_InitStacker","","0","");
A.15.11.2 ReturnPlate (Worklist: Te-Stacker_ReturnPlate)
The advanced worklist command which corresponds to the Te-Stack-ReturnPlate
device command is “Te-Stacker_ReturnPlate”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.34.3 “Te-Stack - ReturnPlate
Command”, 16-108.
Tab. A-95 Advanced worklist command Te-Stacker_ReturnPlate, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 tower expression stacker tower
4 needs_allwd_lw expression specify 1 (needs a specific labware type)
5 allowed_labware expression required labware type
Example:
FACTS("Te-Stacker","Te-Stacker_ReturnPlate","2","1","96_Well_Microplate");
A - 176 Freedom EVOware Software Manual, 393172, en, V2.3