Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Merge Plates Wizard
15.31.4 Merge Plates Wizard, Step 4 of 7
Select the destination plate parameters:
Fig. 15-48 Merge Plates wizard, step 4 of 7
Click on the destination plate you want to use
Select the destination plate by clicking on the labware in the Worktable Editor.
The protected field then shows the type or the label (name) of the selected
item.
Select the liquid class
Choose the required liquid class for the destination plate(s) from the pull down
list. The list only shows liquid classes which are suitable for the current
configuration of the pipetting instrument.
Wash tips
This option only appears if you are using fixed tips. Choose the required
washing method.
Change DiTis
This option only appears if you are using DITIs (disposable tips). Choose the
required method for replacing the DITIs.
Select the waste site
Choose the waste unit you want to use from the pull down list. The list shows
all waste units which are currently positioned in the Worktable Editor. The
worktable grid position is shown in brackets. You must first put a wash station
with waste unit in the Worktable Editor. Alternatively, specify the worktable
position for the waste by clicking on it in the Worktable Editor. If only one
waste unit is present, it is chosen automatically.
When using multi-pipetting mode, Freedom EVOware uses the chosen waste
for discarding the excess volume before aspirating again from the same
source. See also 15.5 “Periodic Wash Command”, 15-10.
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 81