Software Manual Freedom EVOware Standard 2.3 Freedom ...

16 - Device Commands
Commands for the Ultra Reader
See 16.42 “Specifying Output Filenames for Reader Data”, 16-128 for a
description of the placeholders which can be used to generate reader data file
names.
To view or edit the execution parameters again later, right-click on the process
step in the Process Editor and choose Edit Parameters in the context menu.
Objects
The Measure command operates on an object of type Sample or a derived type
with default name MP.
Pre-actions and post-actions
The labware is brought to the Ultra location with a RoMa MoveObject command
and the door of the reader is opened with the Open command. After the
measurement, the labware is brought back to its Base location with another RoMa
MoveObject command and the door is closed with the Close command.
16.37.7 Ultra Reader - Multilabel Command
The Multilabel command performs up to four consecutive measurement steps on
the same labware using external software. The labware does not have to leave
the reader in between measurements. Multi labeling allows different components
(labelled with different fluorophores) to be detected in one operation.
Execution parameters
You are prompted to specify the following execution parameters when you add
this command to your script or process:
Fig. 16-89 Ultra Reader Multilabel command
Measurement parameters
For each measurement step you want to perform, check the corresponding
checkbox and click Edit. The RdrOLE reader interface software then prompts
you to specify the measurement parameters. Refer to the RdrOLE online help
and manual for more information.
Note: RdrOLE must be configured to connect to the chosen reader. In Freedom
EVOware’s offline mode, you must start RdrOLE and choose the reader manually.
16 - 122 Freedom EVOware Software Manual, 393172, en, V2.3