Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
A.15.4.5 Get DITIs (Worklist: GetDITI)
The advanced worklist command which corresponds to the Get DITIs script
command is “GetDITI”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 15.7 “Get DITIs Command”,
15-13.
Tab. A-19 Advanced worklist command GetDITI, parameters
Par. Name Type Range Explanation
1 tipMask integer 1 - 255 selected tips, bit-coded
(tip1 = 1, tip8 = 128)
2 type integer 0 - 3 DITI index (see 9.4.5 “Labware Types
and DITI Types”, 9-32, DITI Index).
3 options integer 0 - 1 bit-coded options:
1 = if diti not fetched try 3 times then go
to next position
4 arm integer 0 - 1 number of the LiHa performing the
action:
0 = LiHa 1
1 = LiHa 2
Example:
GetDITI(240,0,0,0);
A.15.4.6 Drop DITIs command (Worklist: DropDITI)
The advanced worklist command which corresponds to the Drop DITIs script
command is “DropDITI”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 15.8 “Drop DITIs Command”,
15-14.
Tab. A-20 Advanced worklist command DropDITI, parameters
Par. Name Type Range Explanation
1 tipMask integer 0 - 255 selected tips, bit-coded
(tip1 = 1, tip8 = 128)
2 grid integer 1 - 67 DITI waste location - grid position
3 site integer 0 - 127 DITI waste location - (site on carrier - 1)
4 airgap floating point 0 - 100 volume of airgap in µl which is aspirated
after dropping the DITIs
5 airgap speed integer 1 - 1000 speed of airgap aspiration in µl/s
6 arm integer 0 - 1 number of the LiHa performing the
action:
0 = LiHa 1
1 = LiHa 2
Freedom EVOware Software Manual, 393172, en, V2.3 A - 127