Software Manual Freedom EVOware Standard 2.3 Freedom ...

10 - Configuring Liquid Classes
LiHa Liquid Classes for Fixed Tips and DiTis
10.1.2 Type Parameters for Liquid Classes
Freedom EVOware uses these parameters to select the best suited sub-class for
a specified tip type and pipetting volume.
Fig. 10-3 Type parameters for liquid classes
Tip Type
Select the tip type. The following tip types are available:
– Standard tips
– DITI (disposable tips)
– Std. & Low Vol. (standard tips with the low volume option)
– DITI & Low Vol. (disposable tips with the low volume option)
– Te-MO Fixed tips (96 tips)
– Te-MO DITI tips (96 tips)
– Te-MO 384 (384-tip pipetting head)
– MCA96 Fixed (Multi-Channel Arm with fixed tips)
– MCA96 DITI (Multi-Channel Arm with disposable tips)
– MCA384 Fixed (Multi-Channel Arm with fixed tips)
– MCA384 DITI (Multi-Channel Arm with disposable tips)
The following options are only intended for research applications: Low
Volume, Te-MO tips (all types).
Volume Range
If you check the Use for All Volumes checkbox, the aspirate, dispense and
calibration parameters for this sub-class are valid for all pipetting volumes.
If this box is not checked, you must specify the minimum volume and the
maximum volume. Freedom EVOware will then use this sub-class during
pipetting if the following expression is true:
Minimum Volume ≤ pipetting volume < Maximum Volume
10.2 LiHa Liquid Classes for Fixed Tips and DiTis
The LiHa (Liquid Handling Arm) is a robot arm on the pipetting instrument which is
mounted on the X-slide and typically holds four or eight pipetting tips.
10.2.1 LiHa Aspirate Parameters (Fixed Tips and DiTis)
Freedom EVOware uses these parameters when aspirating or mixing with LiHa
fixed tips or DITIs. The illustrations at the top right of the dialog box show
Freedom EVOware Software Manual, 393172, en, V2.3 10 - 7