Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Te-MO Commands
Add the following line to move by 20 instrument steps in the Y direction:
DITI_SIDE_STEPS_Y=20
Add the following line to move by 15 instrument steps in the Z direction:
DITI_SIDE_STEPS_Z=15
Recommended value for DITI_SIDE_STEPS_X when using this feature: -180
Recommended value for DITI_SIDE_STEPS_Y when using this feature: 0
Recommended value for DITI_SIDE_STEPS_Z when using this feature: 90
To disable this feature, set the values to 0 or remove the entries from the
evoware.opt file.
The above settings only affect the Te-MO Drop DITIs command.
Note: Freedom EVOware must be re-started for the changes to take effect.
Configuration files are protected with checksums. When you re-start Freedom
EVOware after editing evoware.opt, you will be warned that this file now has an
invalid checksum. Confirm the prompt with Yes and proceed as follows to repair
the checksum:
• Click Configure in the Toolbar to start the Configuration Tool. You will be
warned again that evoware.opt has an invalid checksum and you will be
asked if you want to checksum to be repaired. Click Yes. Then Click Exit to
return to Freedom EVOware.
15.56.8 Te-MO Get Tip Block Command
The Te-MO Get Tip Block command is used to pick up a tip block from a specified
position on the Te-MO.
Fig. 15-92 Te-MO Get Tip Block command
The parameters of the Te-MO Get Tip Block command are as follows:
Position
Specify the position where the Te-MO should get the tip block by clicking on
the Te-MO tip block in the Worktable Editor. The type or label (name), the Te-
MO grid position and the site of the tip block are then shown in the gray
(protected) fields, see also Tab. 8-9 “Te-MO 3x5 site numbers”, 8-104. You
must first put a Te-MO tip block in the Worktable Editor at the required
position. You can only put Te-MO tip blocks on the middle slide of the Te-MO.
15 - 134 Freedom EVOware Software Manual, 393172, en, V2.3