Software Manual Freedom EVOware Standard 2.3 Freedom ...

13 - Overview of Freedom EVOware Commands
Overview of Script Commands
Tab. 13-3 Script programming commands (cont.)
Sub-Routine - The Sub-Routine command executes another script as part of the current
script. The Sub-Routine command is not available in Freedom EVOware Plus.
See 15.49 “Sub-Routine Command”, 15-113.
Execute VB Script – The Execute VB Script command is used to execute a Visual
Basic (VB) script from within an Freedom EVOware script. See 15.50 “Execute VB
Script Command”, 15-114.
Notification - The Notification command is used to send an email from within a script
(e.g. to inform an operator in another room that a certain process has finished). It can
also be used to send an automatic email if an error occurs during script execution.
See 15.51 “Notification Command”, 15-116.
Start Script - The Start Script command starts another script from the currently running
script, which is terminated. In contrast to sub-routines, the new script can use a
different worktable layout to the original script. The Start Script command is not available
in Freedom EVOware Plus. See 15.52 “Start Script Command”, 15-117.
On Error Goto - The On Error Goto command is used to jump to a specified line in
the script if an error occurs during script runtime. Error recovery commands then allow
the pipetting script to react automatically to the error. See 15.53 “On Error Goto Command”,
15-118.
Resume - The Resume command is used together with the On Error Goto command
and specifies where to resume running the script after executing the error recovery
commands. See 15.54 “Resume Command”, 15-119.
End Script - The End Script command is used to stop the pipetting script prematurely
and to specify a return code (error code) for the script. It is typically used together with
error recovery commands. See 15.55 “End Script Command”, 15-120.
13.1.4 Commands for the Te-MO, Overview
The following table lists the commands for the Te-MO.
To use these commands in Freedom EVOware Plus, add the device command
“Te-MO - Pipette” to your process; this opens the Script Editor (see 16.36.2, 16-
120).
Tab. 13-4 Te-MO commands
Te-MO Aspirate – The Te-MO Aspirate command is used to pick up liquid from specified
positions on the Te-MO. It is analogous to the Aspirate command for the LiHa.
See 15.56.1 “Te-MO Aspirate Command”, 15-122.
Te-MO Dispense – The Te-MO Dispense command is used to dispense liquid to
specified positions on the Te-MO. It is analogous to the Dispense command for the
LiHa. See 15.56.2 “Te-MO Dispense Command”, 15-124.
Te-MO Mix – The Te-MO Mix command performs a mix operation by aspirating and
then dispensing at the same Te-MO position. It is equivalent to the Mix command for
the LiHa. See 15.56.3 “Te-MO Mix Command”, 15-125.
Te-MO Wash – The Te-MO Wash command is used to wash the Te-MO tips or DITIs
using the specified Te-MO 96 wash block. It is designed for standard Te-MO tip blocks
and DITi pipetting heads with 96 tips. See 15.56.4 “Te-MO Wash Command”, 15-
127.
13 - 6 Freedom EVOware Software Manual, 393172, en, V2.3