Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Export Data Command
Tab. 15-6 Parameters in the report file output by the Export Data command
Column Range Explanation
Position 1 .. number of wells Destination well number or tube number. The numbering
sequence is rear to front and then left to right.
TubeID Max. 32 characters Barcode of destination tube. This column is only used
if the destination is a tube rack (i.e. you are pipetting
into tubes).
In line 2, this column shows the Freedom EVOware
software version.
ScanError 0 .. 4294967295 This column shows barcode scanning errors (if any)
at the destination. See Tab. 15-7, 15-54, below.
In line 2, this column shows the serial number of
pipetting instrument. If you chose to include pooling
balance data in the report file and a Liquid Arrival
Check was carried out when dispensing, the serial
number of the balance is also included in line 2 (see
15.26.4 “Pooling balance data in report files”, 15-
56). The two serial numbers are separated by “/”.
SRCRack Max. 32 characters For dispense commands, this column shows the configuration
name of the source labware.
In line 2, this column shows the configuration name
of the labware for which the report file was created
(the configuration name of the destination labware).
SRCPos 1 .. number of wells For dispense commands, this column shows the
position in the source labware where the liquid came
from.
In line 2, this column shows the total number of wells
in the labware in the x direction.
SRCTubeID Max. 32 characters If the source for a dispense command was a tube
rack, this column shows the barcode of the source
tube.
In line 2, this column shows the total number of wells
in the labware in the y direction.
Volume -7158278 .. +7158278 This column contains the volume in µl which was dispensed
(positive value) or aspirated (negative value).
dest
In line 2, this column shows which pipetting step is
relevant to the Tecan Magellan software if more than
one has been carried out on the same well; see
“Significant pipetting step for Magellan ...”, 15-49
for further information.
15 - 52 Freedom EVOware Software Manual, 393172, en, V2.3