Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Balance Send Command Command
15.66 Balance Send Command Command
The Balance Send Command allows you to send a firmware command directly to
the Mettler balance. For example, you can use it to activate special hardware
features and/or options. This command is only intended for specialists.
Fig. 15-108 Balance Send Command command
The parameters of the Balance Send Command command are as follows:
Command
Specify the firmware command you want to send to the balance. See the
respective hardware manual for a list of firmware commands. Firmware
commands are nearly always written uppercase.
Wait for termination of command
If you check this checkbox, the pipetting script will wait for the firmware
command to finish before continuing; otherwise the pipetting script will be
continued immediately.
Store response in variable
Some firmware commands terminate with a return parameter (string or
numeric value). Check this checkbox if you want to store the return parameter
in a variable. See the respective hardware manual for information on return
parameters from firmware commands.
Variable: Specify the name of the variable you want to use.
Store error code in variable
All firmware commands terminate with an error code.The error code is 0 if the
command was executed with no errors. Check this checkbox if you want to
store the error code in a variable.
Variable: Specify the name of the variable you want to use.
WARNING
Risk of injury to operating personnel or damage to the equipment
• Take care when sending firmware commands. Sending the wrong commands
can result in a malfunction of the balance or cause damage to the hardware.
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 157