Software Manual Freedom EVOware Standard 2.3 Freedom ...

8 - Configuration Tool
Device Driver Configuration
Miscellaneous panel
Initialization timeout
Specify the maximum duration of the device initialization procedure. An error
message will be output if initialization is not completed within this time.
Advanced DITI handling
This checkbox is not relevant for the MCA384 and should be ignored.
Allow stacker commands in script
This setting is only relevant for Freedom EVOware Plus. When you create a
pipetting script for the MCA384 in an MCA384 Pipette process step, the
Commands section of the Control Bar only shows relevant and/or permissible
script commands. Te-Stack commands are not shown because stacker
actions are normally part of a robot move or programmed using a separate Te-
Stack process step. Check this checkbox to show Te-Stack commands in the
Control Bar when you create a pipetting script for the MCA384. This is
intended for special applications, above all for getting nested DITIs for the
MCA384 from the stacker. The Te-Stack commands are only shown if you
have installed the Te-Stack driver.
In case of script error panel
Request system pause
Check this checkbox if you want the driver to request a system pause if a
script error is detected during command execution.
Move panel
Grip Detection
Specify whether grip detection should be used.
Home after move
Specify whether the MCA384 should be moved to its home position after each
move. This may be necessary for some worktable layouts, but will reduce
system performance.
Regrip location
This setting is analogous to the regrip location for the RoMa. See
8.5.23.2 “Plate Robot Configuration - Settings Tab”, 8-86, Regrip location.
Freedom EVOware Software Manual, 393172, en, V2.3 8 - 67