Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
Example:
Aspirate(15,"Water","5.5","5.5","4.5","4.5",”0”,”0”,”0”,”0”,”0”,”0”,”0”,”0”,15,2,1,"0C0
80N000000000000",0,0);
A.15.4.2 Dispense (Worklist: Dispense)
The advanced worklist command which corresponds to the Dispense script
command is “Dispense”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 15.2 “Dispense Command”,
15-3.
Tab. A-16 Advanced worklist command Dispense, parameters
Par. Name Type Range Explanation
1 tipMask integer 0 - 255 selected tips, bit-coded
(tip1 = 1, tip8 = 128)
2 liquidClass string1 liquid class name
3 -
14
volume expr[12] 12 expressions which specify the volume
for each tip. Specify 0 for tips which
are not used or not fitted.
15 grid integer 1 - 67 labware location - carrier grid position
16 site integer 0 - 127 labware location - (site on carrier - 1)
17 spacing integer 1 - ... tip spacing
18 wellSelection string1 bit-coded well selection (see
A.15.3 “Well Selection”, A-120)
19 noOfLoopOptions integer 0 - 7 number of loop options required. If nonzero,
parameters 20 - 22 are included n
times, where n = noOfLoopOptions. a)
20 loopName string1 loop name
21 action integer 0 - 3 loop action:
0 = vary the column
1 = vary the row
2 = vary the well
3 = vary the rack
22 difference integer number (“vary by”) which is used for the
loop action (parameter 10)
23 arm integer 0 - 1 number of the LiHa performing the
action:
0 = LiHa 1
1 = LiHa 2
a) See A.15.4.11, A-131 for an example which uses loop options.
Example:
Dispense(255,"Water","5.5","5.5","4.5","4.5",”0”,”0”,”0”,”0”,”0”,”0”,”0”,”0”,15,2,1,"0
C08000000p¯000000",0,0);
A - 124 Freedom EVOware Software Manual, 393172, en, V2.3