Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Replicates Wizard
Fig. 15-33 Copy Plate wizard, step 4 of 4
Select the start position (top left) of the destination wells
Select the required position of the destination wells by clicking with the
mouse. The same selection of wells will be used for all destination plates. An
error message will be displayed if the position you choose does not allow all of
the source wells to fit on the destination plate (to avoid this, choose a start
position towards the top left of the plate).
Click Finish Wizard when you have made all of your entries. This creates a set of
script commands which carry out the required actions.
Note: Click the “-” button in the Wizard command icon in the Script Editor if you
want to collapse and hide all of the script lines between Wizard and Wizard End.
The “-” button changes to “+”. Click the “+” button to show the script lines again.
15.29 Replicates Wizard
The Replicates wizard creates a set of script commands which make one or more
repetitions (copies) of selected wells on the source plate on one or more
destination plates. All of the destination plates will be identical. You can only
create horizontal replicates.
After you have completed all of the steps in the wizard, it creates script commands
which carry out the required actions and inserts them in the Script Editor window
at the currently selected position. If necessary, the script commands can then be
edited if you want to include some special features.
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 63