Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
Tab. A-78 Advanced worklist command Magellan_Open, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 exec_parameters expression no execution parameters (specify an
empty string)
4 needs_allwd_lw expression specify 0 (does not need a specific labware
type)
5 allowed_labware expression not relevant (specify an empty string)
Example:
FACTS("Magellan","Magellan_Open","","0","");
A.15.7.4 Execute1 (Worklist: Magellan_Close)
The advanced worklist command which corresponds to the Magellan-Close
device command is “Magellan_Close”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.5.4 “Hettich Centrifuge -
ExecuteN Command”, 16-17.
Tab. A-79 Advanced worklist command Magellan_Close, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 exec_parameters expression rpm,duration,start ramp, stop ramp, temperature
4 needs_allwd_lw expression specify 0 (does not need a specific labware
type)
5 allowed_labware expression not relevant (specify an empty string)
Example:
FACTS("Magellan","Magellan_Close","","0","");
A.15.7.5 Measure (Worklist: Magellan_Measure)
The advanced worklist command which corresponds to the Magellan-Measure
device command is “Magellan_Measure”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.5.5 “Hettich Centrifuge -
MoveToPos Command”, 16-18.
A - 166 Freedom EVOware Software Manual, 393172, en, V2.3