Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Replicates Wizard
15.29.2 Replicates Wizard, Step 2 of 5
Select the destination plate parameters:
Fig. 15-35 Replicates wizard, step 2 of 5
Click on the first destination plate you want to use
Select the destination plate by clicking on the labware in the Worktable Editor.
The protected field then shows the type or the label (name) of the selected
item.
If you have chosen to make more than one replicate, Freedom EVOware will
choose additional labware of the same type automatically by searching the
worktable from rear to front and then from left to right (you cannot select it
yourself). Make sure there is enough labware on the worktable for all of the
copies and choose the left-most and top-most plate for the first copy.
Otherwise the script which is created will contain errors (faulty script lines are
marked in red).
Select the liquid class
Choose the required liquid class for the destination plate(s) from the pull down
list. The list only shows liquid classes which are suitable for the current
configuration of the pipetting instrument.
How many replicates of each well do you want to create
Select how many replications of the source plate wells you want to make
(range: 1 to 24). The maximum number of replications also depends on how
many wells are available on the destination plate. For example, if you want to
replicate four wells three times, the replications will occupy 12 wells on each
of the destination plates.
How many plate copies do you want to create
Select how many copies of the replications you want (range: 1 to 16). All of
the destination plates will be identical.
Replication sequence mode
This is used to select the placement on the destination wells:
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 65