Software Manual Freedom EVOware Standard 2.3 Freedom ...

18 - Error Handling
Error Dialogs
Send
This button lets you send a firmware command directly to the instrument and
is only intended for specialists. Specify the required command in the
Command field and click Send. For example, “A1RPZ0” returns the current Z
position of each of the LiHa tips. See the respective instrument manual for a
list of firmware commands. Firmware commands are nearly always written
uppercase.
Error: All firmware commands terminate with an error code. After clicking the
Send button, the error code is shown in this (protected) field. The error code is
0 if the command was executed with no errors.
Answer: Some firmware commands terminate with one or more return
parameters (numeric values) separated by commas. After clicking the Send
button, the return parameters are shown in this (protected) field.
WARNING
Risk of injury to operating personnel or damage to the equipment
• Take care when sending firmware commands. Sending the wrong commands
can damage the instrument or objects in its workspace, hurt yourself or other
people.
18.1.24 WRC Errors
The Wash & Refill Center is a supporting device for the Te-MO which is connected
to the Te-MO wash block through tubing. The following two errors can be output
by the Wash and Refill Center. See 18.1.23 “WRC/Te-MO Error”, 18-23 for
information on additional Te-MO WRC errors.
18.1.24.1 WRC Empty Error
The following dialog box is shown during a Te-MO wash cycle if the wash block of
the Wash & Refill Center (WRC) is empty. You will be prompted to refill the wash
block:
Fig. 18-25 Wash & Refill Center error dialog box
The buttons in the dialog box are as follows:
OK
The pumps will be started and will continue to run until the liquid reaches the
specified upper level or the user stops the pumps.
18 - 24 Freedom EVOware Software Manual, 393172, en, V2.3