Software Manual Freedom EVOware Standard 2.3 Freedom ...

8 - Configuration Tool
Device Driver Configuration
Note: Freedom EVOware compares the initial worktable layout with the worktable
layout which is required by the script. For each labware item which needs to be
moved, it then uses the specified pre-action and post-action to create and
configure the RoMa movements which will be needed.
Default replace action
Choose the default action to be used by Liquid Handling Arm commands
when replacing DITIs and specify the execution time to be used when
scheduling this operation.
Note: Freedom EVOware compares the initial worktable layout with the worktable
layout which is required by the script. For each DITI rack, it then uses the
specified replace action to create and configure the RoMa movements which will
be needed when the DITI rack needs to be replaced.
Default start process action for advanced DITI handling
This field is not relevant for the MCA96 and should be ignored.
8.5.12.4 MCA96 Configuration - Plugins Tab
Plugins are software tools from third-party suppliers which are used to control
special devices. The Plugins tab is used to assign the MCA96 commands which
are needed by the device.
Fig. 8-30 Plugins tab of the MCA96 driver
Associate Plugin Tools panel
Choose the plugin in the Tools panel, choose the MCA96 command which the
device should use and click Add.
8.5.12.5 MCA96 Configuration - Firmware Commands
The following firmware commands (command strings) are pre-configured for the
MCA96 in the Test tab of the Configuration Tool:
Get RSP
Requests the pipetting instrument type the device is connected to.
Freedom EVOware Software Manual, 393172, en, V2.3 8 - 65