Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Export Data Command
the separate error codes. The Te-MO does not have a barcode scanner and does
not generate barcode scanning errors.
Tab. 15-7 Barcode scanning error codes in the report file output by the Export Data command
Code
(decimal)
Code
(hex) Caused by Explanation
0 0 - No error.
16 10 Instrument A barcode could not be read by the PosID or the
PosID-3 scanner.
32 20 Instrument The same labware was scanned again (at the same
grid position or at a new worktable position of the
same labware) and the scanned barcode did not
match the previously scanned barcode. If this error
occurs, Freedom EVOware updates the stored information
for the labware with the newer barcode.
64 40 Instrument An identical barcode was scanned at an unexpected
grid position. Either (a) two labware items have identical
barcodes or (b) the labware was moved to a different
grid position manually. If this error occurs,
Freedom EVOware assumes that (b) has taken
place and updates the stored information for the labware
with the new position.
4096 1000 User The user entered the barcode manually after a scanning
error.
8192 2000 User The user chose Retry after a barcode scanning
error.
16384 4000 User The user chose Ignore after a barcode scanning
error.
The following table shows possible codes in the Error column. The value is bitcoded.
If several errors occurred, the value shown is the bit-wise addition of the
separate error codes.
Tab. 15-8 Pipetting error codes in the report file output by the Export Data command
Code
(decimal)
Code
(hex) Caused by Explanation
0 0 - No error.
1 1 Instrument No liquid was detected.
2 2 Instrument Not enough liquid was detected.
4 4 Instrument Clot was detected.
8 8 Instrument A dilutor error occurred during pipetting.
15 - 54 Freedom EVOware Software Manual, 393172, en, V2.3