Software Manual Freedom EVOware Standard 2.3 Freedom ...

8 - Configuration Tool
Device Driver Configuration
Advanced DITI handling
Check this checkbox if you want to use to use a special driver for exchanging
DITIs. The special driver is not provided with the standard Freedom EVOware
installation.
In case of script error panel
Request system pause
Check this checkbox if you want the driver to request a system pause if a
script error is detected during command execution.
Note: Do not confuse the settings made here with those made in the scheduling/
error handling configuration. The settings in this tab define the reaction of the
system if the Process Script driver outputs an error message during execution of a
pipetting command. The settings for error handling take effect if the pipetting
command has already been stopped due to an error.
8.5.32.3 Process Script Configuration - Command Generation Tab
The Command Generation tab is used to make settings for the default pre-actions
and post-actions to be used when generating commands for the Process Script.
The settings are only relevant to Freedom EVOware Plus.
Fig. 8-61 Command Generation tab of the Process Script driver
Command Generation panel
Default pre-action
This field is not relevant for the Process Script and can be ignored.
Default post-action
This field is not relevant for the Process Script and can be ignored.
Default replace action
This field is not relevant for the Process Script and can be ignored.
8 - 112 Freedom EVOware Software Manual, 393172, en, V2.3