Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
System Tools for Freedom EVOware
The script or process runs in offline mode and Freedom EVOware reports
errors but errors are not listed in the log window or the log file.
If your script uses a barcode scanner, in offline mode you will be prompted to
enter the barcode manually. Manual barcode entry is reported in the log file
and is considered to be an error in this case because the barcode scanner is
missing.
A Get DITIs or Te-MO Get DITIs command causes a DITIs already mounted
error even though you haven’t yet mounted any DITIs in the script.
Freedom EVOware remembers whether you still have DITIs mounted from a
previous pipetting script, even if the PC has been re-started in the meantime.
The Freedom EVOware worklist specifies all eight tips but Freedom
EVOware only uses the first tip.
Freedom EVOware automatically optimizes script execution by grouping
together aspirate and dispense commands etc. where possible. The worklist
should be written as follows if you want to use multiple tips:
A; ... (for tip 1)
D; ... (for tip 1)
W; ... (for tip 1)
A; ... (for tip 2)
D; ... (for tip 2)
W; ... (for tip 2)
etc.
It is possible to write a Freedom EVOware worklist for four standard tips and
four Ditis?
No, you can only write a worklist for the same tip type. Load several worklists
in your script and execute them using the Worklist - Execute loaded worklists
command. They will be executed in chronological order of loading.
The pipetted volumes are completely wrong (too much or not enough
liquid).
Check the LiHa configuration. The configured dilutor capacity must be
appropriate for the tips which are mounted.
The LiHa moves to the required position but ignores aspirate and dispense
commands.
In the LiHa configuration, check whether Tip is broken is activated (the
checkbox is activated if you click the Deactivate button in the Diluter Error
dialog box). Check the checkbox(es) to enable the pipetting channel(s) again.
The trailing airgap (TAG) is aspirated with the tips still in the liquid.
The trailing airgap is aspirated at the Z-position specified in the liquid class
with Retract tips to. A Z-position relative to the liquid level requires liquid level
detection and can not be used if you are carrying out septum piercing (the
septum interferes with the capacitance-based detection system).
A.9 System Tools for Freedom EVOware
The Freedom EVOware installation program also installs the following system
tools:
A - 32 Freedom EVOware Software Manual, 393172, en, V2.3