Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Activate PMP Command
Tip Selection
Select the tips you want to use. You can only select tips which are configured
with the Te-Fill option (see 8.4.2.1 “LiHa (Liquid Handling Arm)”, 8-22, Te-
Fill option).
Open channel to Large Volume Pump
Position the valves in the pipetting instrument to select the liquid path through
the bi-directional pump instead of through the diluter.
Switch 6-way valve
If the Te-Fill is fitted with the 6-way valve option, choose the channel (liquid
container) you want to use. This option is not available if the 6-way valve is not
present and/or not activated.
Open standard liquid channel
Position the valves in the pipetting instrument to select the liquid path through
the diluter instead of through the bi-directional pump.
Channel / Liquid
If the Te-Fill is fitted with the 6-way valve option, choose the channel (liquid
container) you want to use. The pull-down list is not available if the 6-way
valve is not present and/or not activated.
15.18 Activate PMP Command
The Activate PMP command is used to activate the PMP (Pressure Monitored
Pipetting) function at the appropriate point in your pipetting script. You must do
this before getting (mounting) the PMP-controlled DiTis.
This command is only shown in the Control Bar if you are using DiTis and you
have enabled the PMP option (see 17.6.1 “Activating the PMP Option”, 17-17).
Certain restrictions apply to the pipetting commands which are allowed between
the Activate PMP command and a subsequent Deactivate PMP command (see
17.6.2 “Permissible sequence of script commands for the PMP option”, 17-18).
Fig. 15-18 Activate PMP command
The parameters of the Activate PMP command are as follows:
Tip Selection
Select the tip or tips whose PMP function you want to activate. You can only
choose tips which are configured with DITIs and with the PMP option.
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 29