12.01.2014 Views

Software Manual Freedom EVOware Standard 2.3 Freedom ...

Software Manual Freedom EVOware Standard 2.3 Freedom ...

Software Manual Freedom EVOware Standard 2.3 Freedom ...

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

15 - Script Commands<br />

Te-MO Commands<br />

Blowout airgap<br />

Specify the volume of air to aspirate directly before getting the tip block<br />

(range: 0 to 150 µl). When the tips are washed, the air is dispensed at the end<br />

of the wash procedure and serves to make sure that all of the wash liquid<br />

remaining in the tips is discarded. In contrast to the Leading Airgap (which is<br />

specified in the liquid classes), the blowout airgap is only relevant for washing<br />

the tips and is not dispensed by the Dispense command.<br />

15.56.9 Te-MO Drop Tip Block Command<br />

The Te-MO Drop Tip Block command is used to put down the tipblock at a<br />

specified position on the Te-MO.<br />

Fig. 15-93 Te-MO Drop Tip Block command<br />

The parameters of the Te-MO Drop Tip Block command are as follows:<br />

Back to source<br />

This option returns the tip block back to the Te-MO carrier and slide position<br />

from where it was fetched with the Te-MO Get Tip Block command. I:<br />

Note: If you switch off the pipetting instrument with the tip block still attached, it<br />

will forget the Te-MO carrier and slide position from where the tip block was<br />

fetched. The option Back to source will then display an error message when the<br />

script is validated.<br />

Back to position<br />

Specify the position where the Te-MO should discard the tip block by clicking<br />

on the Te-MO tip block in the Worktable Editor. The type or label (name), the<br />

Te-MO grid position and the site of the tip block are then shown in the gray<br />

(protected) fields, see also Tab. 8-9 “Te-MO 3x5 site numbers”, 8-104. You<br />

must first put a Te-MO tip block in the Worktable Editor at the required<br />

position. The gray (protected) field then shows the type or the label (name) of<br />

the selected item. You can only put Te-MO tip blocks on the middle slide of the<br />

Te-MO.<br />

15.56.10 Te-MO Refill Trough Command<br />

The Te-MO trough is a special carrier on the Te-MO which is used as a container<br />

for a reagent liquid. The reagent liquid can be aspirated using the Te-MO pipetting<br />

<strong>Freedom</strong> <strong>EVOware</strong> <strong>Software</strong> <strong>Manual</strong>, 393172, en, V<strong>2.3</strong> 15 - 135

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!