Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Start Timer Command
Wash position
Select the MCA wash block you want to use by clicking on the wash block in
the Worktable Editor. The green (protected) field then shows the label (name)
of the MCA wash block that you have selected. The worktable grid and site
position is shown in brackets.
You can only put MCA Wash Blocks on MCA carriers.
Click Finish Wizard when you have made all of your entries. This creates a set of
script commands which carry out the required actions.
Note: Click the “-” button in the Wizard command icon in the Script Editor if you
want to collapse and hide all of the script lines between Wizard and Wizard End.
The “-” button changes to “+”. Click the “+” button to show the script lines again.
15.34 Start Timer Command
The Start Timer command re-starts one of the 100 internal timers in Freedom
EVOware. If required, you can use this command to re-start a specified timer
several times in the same script.
Fig. 15-60 Start Timer command
The parameter of the Start Timer command is as follows:
Timer
Specify the number of the timer you want to re-start or specify a numeric
variable (range: 1 - 100).
Note: Freedom EVOware automatically starts all timers when the script is started.
15.35 Wait for Timer Command
The Wait for Timer command pauses the execution of the script until a specified
number of seconds have expired since a specified timer was reset.
Fig. 15-61 Wait for Timer command
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 95