Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.5.2 “Hettich Centrifuge -
Open Command”, 16-17.
Tab. A-72 Advanced worklist command Centrifuge_Open, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 exec_parameters expression no execution parameters (specify an
empty string)
4 needs_allwd_lw expression specify 0 (does not need a specific labware
type)
5 allowed_labware expression not relevant (specify an empty string)
Example:
FACTS("Centrifuge","Centrifuge_Open","","0","");
A.15.6.3 Close (Worklist: Centrifuge_Close)
The advanced worklist command which corresponds to the Centrifuge-Close
device command is “Centrifuge_Close”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.5.3 “Hettich Centrifuge -
Close Command”, 16-17.
Tab. A-73 Advanced worklist command Centrifuge_Close, parameters
Par. Name Type Range Explanation
1 devicename string1 name of device
2 commandname string1 name of command
3 exec_parameters expression no execution parameters (specify an
empty string)
4 needs_allwd_lw expression specify 0 (does not need a specific labware
type)
5 allowed_labware expression not relevant (specify an empty string)
Example:
FACTS("Centrifuge","Centrifuge_Close","","0","");
A.15.6.4 Execute1 (Worklist: Centrifuge_Execute1)
The advanced worklist command which corresponds to the Centrifuge-Execute1
device command is “Centrifuge_Execute1”.
The parameters of the advanced worklist command are shown in the following
table. For more information on this command see 16.5.4 “Hettich Centrifuge -
ExecuteN Command”, 16-17.
Freedom EVOware Software Manual, 393172, en, V2.3 A - 163