Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Transfer Wizard
15.32.2 Transfer Wizard, Step 2 of 4
Select the destination plate parameters:
Fig. 15-53 Transfer wizard, step 2 of 4
Click on the first destination plate you want to use
Select the destination plate by clicking on the labware in the Worktable Editor.
The protected field then shows the type or the label (name) of the selected
item.
If you have chosen to make more than one copy, Freedom EVOware will
choose additional labware of the same type automatically by searching the
worktable from rear to front and then from left to right (you cannot select it
yourself). Make sure there is enough labware on the worktable for all of the
copies and choose the left-most and top-most plate for the first copy.
Otherwise the script which is created will contain errors (faulty script lines are
marked in red).
Select the liquid class
Choose the required liquid class for the destination plate(s) from the pull down
list. The list only shows liquid classes which are suitable for the current
configuration of the pipetting instrument.
Wash tips after the transfer
This option only appears if you are using fixed tips. Click Yes if you want to
wash the tips after the transfer.
Drop DiTis after the transfer
This option only appears if you are using DITIs (disposable tips). Click Yes if
you want to drop the DITIs after the transfer.
The following settings for the waste and the cleaner do not appear if you have
chosen No (i.e. “wash is not necessary” or “DITI change is not necessary”):
Freedom EVOware Software Manual, 393172, en, V2.3 15 - 87