Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
Tab. A-83 Advanced worklist command PosID3_Scan, execution parameters (cont.)
Par. Name Type Range Explanation
9 carrierID string1 carrier code (first three digits of the carrier
barcode, as defined in the Edit Carrier
dialog box)
10 carrierSerialNumber
string1
not relevant (specify an empty string)
11 scannedBarcod string1 not relevant (specify an empty string)
12 carrierType string1 configuration name of the carrier
13 carrierGrid string1 carrier grid position
14 carrierNoOfSites string1 total number of labware sites on carrier
(specify 1 for strip racks)
15 LABWARE_DEF string1 This label indicates the start of the labware
definition section. This section
(parameters 15 - 23) is repeated n times,
where n is the number of labware sites
to be scanned on the carrier.
16 labwareLabel string1 labware label, as shown on the Freedom
EVOware worktable
17 labwareAlias string1 labware alias (only for labware generated
by Labware Generator), e.g. "GeneratedLabware{001}
18 labwareType string1 configuration name of the labware
19 labwareSite string1 labware location - (site on carrier - 1)
20 labwareNumber-
OfTubes
string1
placeholder for number of tubes which
were scanned (specify 0 in the
advanced worklist command)
21 labwareBarcode string1 not relevant (specify an empty string)
22 labwareScan_err string1 not relevant (specify an empty string)
23 LabwarePipe_err string1 not relevant (specify “None” or an empty
string)
24 BARCODETYPE
_DEF
string1
This label indicates the start of the barcode
types section. This section (parameters
24 - 28) is repeated n times, where
n is the number of barcode types to be
allowed.
Freedom EVOware Software Manual, 393172, en, V2.3 A - 169