Software Manual Freedom EVOware Standard 2.3 Freedom ...

16 - Device Commands
Commands for the Te-VacS
This command is normally used as a pre-action and/or post-action of another
command. It is not normally used as a process step.
16.35.9 Te-VacS - Filtration Command
The Filtration command, which is only available in Freedom EVOware Plus, is
used to specify the sequence of operations to be carried out by the Te-VacS
during the vacuum separation process. Three of the tabs are used to make
general settings. The fourth tab is used to specify the filtration parameters.
To carry out vacuum separation in Freedom EVOware Standard you must use a
combination of the commands SetPressureDiff, ApplyVacuumRear,
ApplyVacuumFront, VentRear, VentFront, PositionPlateRear, PositionPlateFront
and OpenDesaltingValve. The Filtration command in Freedom EVOware Plus is a
high-level command which combines all of these functions.
When setting up your worktable for the Filtration command, you must assign the
labware labels FiltrationPlate and CollectionPlate to the filtration plate and the
collection plate (see 11.7.1 “Assigning a Label (Name) to the Labware”, 11-19).
Execution parameters
You are prompted to specify the following execution parameters when you add
this command to your script or process:
16.35.9.1 General Tab
This tab is used to make general settings.
Fig. 16-81 Te-VacS Filtration command - General tab
Execute on panel
Specify whether you want to use the front SPE block or the rear SPE block.
Freedom EVOware Software Manual, 393172, en, V2.3 16 - 113