Software Manual Freedom EVOware Standard 2.3 Freedom ...

8 - Configuration Tool
Device Driver Configuration
Miscellaneous panel
Initialization timeout
Specify the maximum duration of the device initialization procedure. An error
message will be output if initialization is not completed within this time.
Advanced DITI handling
Check this checkbox if you want to use to use a special driver for exchanging
DITIs. The special driver is not provided with the standard Freedom EVOware
installation.
In case of script error panel
Request system pause
Check this checkbox if you want the driver to request a system pause if a
script error is detected during command execution.
Note: Do not confuse the settings made here with those made in the scheduling/
error handling configuration. The settings in this tab define the reaction of the
system if the Liquid Handling Arm outputs an error message during execution of a
pipetting command. The settings for error handling take effect if the pipetting
command has already been stopped due to an error.
8.5.11.3 Liquid Handling Arm Configuration - Command Generation Tab
The Command Generation tab is used to make settings for the default pre-actions
and post-actions to be used when generating commands for the Liquid Handling
Arm. The settings are only relevant to Freedom EVOware Plus.
Note: See 8.5.32 “Settings for the Process Script”, 8-111 for information on
configuring the Process Script driver.
Fig. 8-27 Command Generation tab of the Liquid Handling Arm driver
Freedom EVOware Software Manual, 393172, en, V2.3 8 - 61