Software Manual Freedom EVOware Standard 2.3 Freedom ...

13 - Overview of Freedom EVOware Commands
Overview of Script Commands
13.1.8 Miscellaneous Commands, Overview
The following table lists the script commands for miscellaneous devices. To use
these commands in Freedom EVOware Plus, add the device command “Liquid
Handling Arm - Pipette” to your process; this opens the Script Editor (see
16.13.2, 16-47).
Tab. 13-8 Commands for miscellaneous devices
Waterbath Control – The Waterbath Control command is used to control the waterbaths
for the Te-Flow option. The Te-Flow option provides support for the In Situ
Hybridization method. See 15.64 “Waterbath Control Command”, 15-154.
Balance - The Balance command is used to read a weight from the Mettler balance
and store it in a variable. See 15.65 “Balance Command”, 15-155.
Balance Send Command - The Balance Send Command command allows you to
send a firmware command directly to the Mettler balance. This command is only
intended for specialists. See 15.66 “Balance Send Command Command”, 15-157.
Send Command - The Send Command command allows you to send a firmware
command directly to the pipetting instrument. This command is only intended for specialists.
See 15.67 “Send Command Command”, 15-158.
13.1.9 Commands for the MCA96 (Multi Channel Arm 96), Overview
The following table lists the script commands for the MCA96.
Tab. 13-9 Commands for the MCA96
Aspirate - The MCA96 Aspirate command is used to pick up liquid from specified
positions on the worktable of the pipetting instrument using the multi channel arm.
See 15.68.1 “MCA96 Aspirate Command”, 15-159.
Dispense - The MCA96 Dispense command is used to dispense liquid to specified
positions on the worktable of the pipetting instrument using the multi channel arm.
See 15.68.2 “MCA96 Dispense Command”, 15-161.
Mix - The MCA96 Mix command performs a mix operation by aspirating and then dispensing
at the same position using the multi channel arm. See 15.68.3 “MCA96 Mix
Command”, 15-162.
Wash - The MCA96 Wash command is used to wash MCA96 tips or MCA96 DITIs
using the specified MCA96 wash block. See 15.68.4 “MCA96 Wash Command”,
15-164.
Get DITIs - The MCA96 Get DITIs command is used to pick up disposable tips for the
multi channel arm from a specified position on the worktable of the pipetting instrument.
See 15.68.5 “MCA96 Get DITIs Command”, 15-167.
Drop DITIs - The MCA96 Drop DITIs command is used to return the disposable tips
of the multi channel arm to a specified position on the worktable of the pipetting instrument.
See 15.68.6 “MCA96 Drop DITIs Command”, 15-168.
Get Tipblock - The MCA96 Get Tip Block command is used to pick up a tip block for
the MCA96 from a specified position on the worktable of the pipetting instrument. See
15.68.7 “MCA96 Get Tip Block Command”, 15-170.
Freedom EVOware Software Manual, 393172, en, V2.3 13 - 9