Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Advanced Worklist Commands
Tab. A-57 Advanced worklist command PosID, parameters (cont.)
Par. Name Type Range Explanation
5 scanSpeed integer 30 - 400 speed with which the labware barcode
should be scanned
6 noBarcodeTypes integer 1 - 23 the number of different barcode types to
be accepted. Parameters 7 - 10 are
included n times, where n = noBarcode-
Types
7 barcodeType integer 1 - 23 barcode type:
1 = 2 of 5 Interleaved
2 = Codabar
3 = Code128
4 = Code39
5 = EAN-13
6 = EAN-13 with 2 Supplement
7 = EAN-13 with 5 Supplement
8 = EAN-8
9 = EAN-8 with 2 Supplement
10 = EAN-8 with 5 Supplement
11 = UPC-A
12 = UPC-A with 2 Supplement
13 = UPC-A with 5 Supplement
14 = UPC-E
15 = UPC-E with 2 Supplement
16 = UPC-E with 5 Supplement
17 = C.I.P.
18 = Code32
19 = Code39 Full ASCII
20 = Code93
21 = Code93 Full ASCII
22 = MSI
23 = EAN-128
8 barcodeLength integer 0 - 30 0 = do not check the barcode length
1 to 30 = required barcode length
Refer to the published barcode specifications
for information on the allowed
length for each barcode type. Also see
C.3 “Recommendations when using barcodes”,
C-4.
9 checkDigitMode integer checksum checking mode: a)
0 = do not evaluate the checksum
1 = evaluate and transmit
2 = evaluate but don’t transmit
10 startStopMode integer handling of start/stop codes: a)
0 = start/stop code is not required
1 = required and transmit
2 = required but don’t transmit
11 options integer 0 - 127 bit-coded options as follows:
1 = No prompt for scan errors
2 = Write file with scan results
4 = Ignore duplicate barcodes
A - 154 Freedom EVOware Software Manual, 393172, en, V2.3