Software Manual Freedom EVOware Standard 2.3 Freedom ...

6 - Menus
Freedom EVOware Toolbar
information and the hardlock (dongle) ID. If there is no hardlock fitted, “Non
upgradable hardlock” is shown.
Version information for the currently installed device drivers can be viewed using
the Configuration Tool (see 8.4.1.1 “Device Information Tab”, 8-21).
It also shows the intended use of your Freedom EVOware configuration - general
purpose applications or research use only. See 3.2 “Intended Use of the Freedom
EVOware Software”, 3-3 for more information.
See 3.1 “Overview of Freedom EVOware”, 3-1 for an introduction to the
Freedom EVOware software.
6.7 Freedom EVOware Toolbar
The toolbar gives you quick access to commonly used functions:
Fig. 6-10 Toolbar
New
See 6.1.1 “New”, 6-1.
Open
See 6.1.2 “Open”, 6-3
Save
See 6.1.3 “Save”, 6-5.
Initialize
This function is used to manually initialize the arms of the pipetting instrument.
It also initializes all of the optional devices.
Each time Freedom EVOware or an Freedom EVOware script or process is
started, the status of the instrument arms (LiHa, RoMa and PnP) and optional
devices (e.g. Te-MO or Te-VacS) is checked and they are initialized if
necessary. In addition, a full initialization sequence is carried out when
Freedom EVOware is started for the first time after powering up the pipetting
instrument.
Manual initialization is not normally necessary, but can be used as a quick
check that the instrument is responding properly. When you use the Initialize
function, Freedom EVOware determines automatically whether it is necessary
to carry out a full or a partial initialization sequence.
See 8.4.2.8 “Arm Initialization”, 8-31 for more information.
Print
See 6.1.6 “Print”, 6-6.
Configure
See 6.5.3 “Configure”, 6-16.
Startup
See 6.1.7 “Start Up Wizard”, 6-7.
Maintenance
To run a maintenance script, click this button and choose the script from the
pull-down list. See 6.4.2 “Run Maintenance”, 6-10.
6 - 18 Freedom EVOware Software Manual, 393172, en, V2.3