Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Condition Command
Comparison operator
Choose one of the four comparison operators from the pull-down list:
– is equal to
– is not equal to
– is bigger than
– is less than
then goto line
Freedom EVOware uses Comment commands as labels (jump destinations)
for the Condition command. Choose the required jump destination from the
pull-down list. The list shows all comments which are currently defined in the
script. Freedom EVOware will continue script execution at the specified line if
the condition is met. Otherwise it will continue script execution at the next line
in the script.
In the Comment command, it is recommended to prefix the label (jump
destination) with underscore (“_”), see the above figure for an example. See
15.37 “Comment Command”, 15-97 for an explanation of this
recommendation.
You can also specify a name for the jump destination in advance and add the
corresponding Comment command to the script later.
Note: Each time you insert a new command in your script or edit an existing
command, Freedom EVOware validates the entire script to check for errors.
During validation, Freedom EVOware uses default values for the variables (see
14.1.12 “Validating a Script Which Contains Variables”, 14-18). For this reason,
the script might run incorrectly even if no errors are detected during validation.
15 - 110 Freedom EVOware Software Manual, 393172, en, V2.3