Software Manual Freedom EVOware Standard 2.3 Freedom ...

15 - Script Commands
Serial Dilution Wizard
Select the waste site
Choose the waste unit you want to use from the pull down list. The list shows
all waste units which are currently positioned in the Worktable Editor. The
worktable grid position is shown in brackets. You must first put a wash station
with waste unit in the Worktable Editor.Alternatively, specify the worktable
position for the waste by clicking on it in the Worktable Editor. If only one
waste unit is present, it is chosen automatically.
When using multi-pipetting mode, Freedom EVOware uses the chosen waste
for discarding the excess volume before aspirating again from the same
source. See also 15.5 “Periodic Wash Command”, 15-10.
Select the cleaner site
This option only appears if you have if you are using fixed tips. Choose the
cleaner unit you want to use from the pull down list. The list shows all cleaner
units which are currently positioned in the Worktable Editor. You must first put
a wash station with cleaner unit in the Worktable Editor. If only one cleaner
unit is present, it is chosen automatically. Alternatively, specify the worktable
position for the cleaner by clicking on it in the Worktable Editor.
Choose a shallow cleaner if you only need to clean the ends of the tips.
Choose a deep cleaner if there is a possibility of contamination along the shaft
of the tip. The deep cleaner requires a larger volume of system liquid and
cleaning takes somewhat longer.
Volumes in cleaner and in waste
These options only appear if you are using fixed tips. Specify the volume of
system liquid which should be used to wash the outside of the tips (volume in
cleaner) and to flush the inside of the tips (volume in waste). Appropriate
settings are chosen automatically. For more information on washing see
15.4 “Wash Tips Command”, 15-8.
Use Fast-Wash Module
If your instrument is fitted with FWO (Fast Wash Option) or MPO (Monitored
Pump Option), check this checkbox to use the Fast Wash module instead of
the dilutors to wash the tips.
Use Pinch Valve
If your instrument is fitted with the Low Volume Option, check this checkbox to
activate the Low Volume Option after washing the tips.
Do you want to mix after dispensing
Click the appropriate radio button. If you choose Yes, you must also specify
how many times to mix and the volume to mix with.
15 - 74 Freedom EVOware Software Manual, 393172, en, V2.3