Software Manual Freedom EVOware Standard 2.3 Freedom ...

A - Appendix A
Parameters in the Evoware.opt file
A.3 Parameters in the Evoware.opt file
The following tables list user-configurable parameters in six different sections of
the evoware.opt file. evoware.opt is in the /Database directory.
These settings should only be changed by specialists.
Note: The parameters in evoware.opt are already configured with suitable values.
The values should only be changed for special applications. Do not change the
values of parameters which are not listed in the following tables.
Add a new line to the respective section of the evoware.opt file if the parameter is
missing.
Default values: Each parameter string is shown below with the default value of
the parameter (some parameters do not have a default value). The parameter
string is not case sensitive.
Note: Freedom EVOware must be re-started for the changes to take effect.
Configuration files are protected with checksums. When you re-start Freedom
EVOware after editing this file, you will be warned that the checksum is invalid.
Proceed as follows to repair the checksum:
• Quit Freedom EVOware and start the Configuration Tool with Start > All
Programs > Tecan > EVOware > Configure. You will be warned again that the
checksum is invalid and you will be asked if you want to repair the checksum.
Click Yes. Then Click Exit and re-start Freedom EVOware. Alternatively, repair
the checksum using the Validate Configuration tool (see A.9.2 “Validate
Configuration Tool”, A-36).
Tab. A-2 Evoware.opt parameters, [OPTIONS] section
Parameter string Description Range, units
Lauda_Pump_Speed=3
Csv_With_Semicolon=0
Speed of pump for Lauda waterbath.
1= Use “;” instead of “,” as the field
separator in the CSV file created
by the Export Data command. This
parameter also controls the field
separator for the Import Variable
and Export Variable commands
(see 15.42.2, 15-107).
It has no influence on the scan.csv
file exported by the PosID command,
which always uses “;” as
the field separator.
1 to 5
0 or 1
Posid_Allocation_Timeout=60000 Time-out for collision avoidance. 0 to ∞, in ms
LiHa_Allocation_Timeout=60000 Time-out for collision avoidance. 0 to ∞, in ms
RoMa_Allocation_Timeout=60000 Time-out for collision avoidance. 0 to ∞, in ms
PnP_Allocation_Timeout=60000 Time-out for collision avoidance. 0 to ∞, in ms
Diluter_OFF=tipMask
Turns the diluter off for the specified
tip(s).
0 to 255,
bit-mapped
Freedom EVOware Software Manual, 393172, en, V2.3 A - 17