Software Manual Freedom EVOware Standard 2.3 Freedom ...

13 - Overview of Freedom EVOware Commands
Overview of Device Commands
Tab. 13-20 Commands for the Heated Incubator (cont.)
StartShaker - The StartShaker command starts the optional shaker of the incubator.
See 16.10.3 “Heated Incubator - StartShaker Command”, 16-41.
StopShaker - The StopShaker command stops the optional shaker of the incubator.
See 16.10.4 “Heated Incubator - StopShaker Command”, 16-41.
InsertPlate - The InsertPlate command must be used each time the RoMa inserts
labware into the incubator slot. The InsertPlate command itself does not move the
labware. It’s purpose is to regulate the power of the slot’s heater. See 16.10.5 “Heated
Incubator - InsertPlate Command”, 16-41.
RemovePlate - The RemovePlate command must be used each time the RoMa
removes labware from the incubator slot. The RemovePlate command itself does not
move the labware. It’s purpose is to tell Freedom EVOware to stop recording information
on the slot temperature to the log file. See 16.10.6 “Heated Incubator - Remove-
Plate Command”, 16-42.
13.2.10 Commands for the Base Incubator, Overview
The following table lists the command for the Base Incubator. The Base Incubator
is a software concept and it is not a device which you can fit to your pipetting
instrument. This command is not necessary in Freedom EVOware Standard.
Tab. 13-21 Commands for the Base Incubator
BaseIncubate - The BaseIncubate command moves the labware back to its base
(labware source) position (e.g. the carousel) and leaves it there at room temperature
for the specified amount of time. The base incubator is a software concept and it is not
a device which you can fit to your pipetting instrument. See 16.11.1 “Base Incubator -
BaseIncubate Command”, 16-44.
13.2.11 Commands for the Room Temperature Incubator, Overview
The following table lists the command for the Room Temperature Incubator, which
is only available in Freedom EVOware Plus. The Incubate command handles
incubating time and plate loading/unloading automatically.
This command is not available in Freedom EVOware Standard. The labware is
loaded into the room temperature incubator using RoMa movement commands.
The incubating time can then be controlled by the Wait For Timer command.
Tab. 13-22 Commands for the Room Temperature Incubator
Incubate - The Incubate command keeps the labware at room temperature for the
specified amount of time. See 16.12.1 “Room Temperature Incubator - Incubate Command”,
16-45.
13.2.12 Commands for the Liquid Handling Arm (LiHa), Overview
The following table lists the device commands for the Liquid Handling Arm (LiHa).
These commands are only available in Freedom EVOware Plus. They are not
13 - 20 Freedom EVOware Software Manual, 393172, en, V2.3